GeoTesting Express is a provider of Geosynthetic Testing Services – ASTM D,Test Method for Determining the (In-plane) Flow Rate per Unit Width and . ASTM D Test Method Determining the (in-plane) Flow Rate Per Unit Width and Hydraulic Transmissivity of a Geosynthetic Using a Constant Head. Last previous edition approved in as D – 2. For referenced ASTM standards, visit the ASTM website, , or contact ASTM Customer.
|Published (Last):||27 December 2011|
|PDF File Size:||8.11 Mb|
|ePub File Size:||5.76 Mb|
|Price:||Free* [*Free Regsitration Required]|
Comparative tests as directed in 5. Please reply me widthin 24 hours. I would like your verified suppliers matching service! The test is intended primarily as an index test but can be used also as a performance test when the hydraulic gradients and specimen contact surfaces are selected by the user to model anticipated field conditions.
The test specimens should then be randomly assigned in equal numbers to each laboratory for testing. Enter your email please. Send your message to this supplier. Please reply me within 24 hours. Pressure Pump and Testing Cylinder Easy to operate, the result more accurate.
Historical Version s – view previous versions of standard. For the best results, we recommend including the following details: If bias is found, either its cause must be found and corrected or the purchaser and supplier must agree to interpret future test results in light of the known bias.
Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product. Inquiry Sent Successfully Confirmation email has been sent: Forward Filter Manufacturers Co.
As a minimum, the two parties should take a asym of test specimens that are as homogenous as possible and that are formed from a lot of the material of the type in question. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Site Member 3 Years. Competent statistical assistance is recommended for the investigation of bias.
Your message must be between d716, characters! Application Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Products – BT Technology
Your email address is incorrect! Your message has been sent to the following suppliers. Features Diaphragmpressurizing Astk pressure, Keeping pressure long time, easy to maintain, can greatly reduce the testing cost.
The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Link to Active This link will always route to the current Active version of the standard. Recommended Quality Verified Suppliers.
Please enter 20 to e4716 to contact this supplier! Combining values from the two systems may result in non-conformance with the standard. The flow of water within the plane of a geotextile or geotextile-related product is measured under varying normal compressive stresses, with typical hydraulic gradients and with asmt contact surfaces. The average results from the two laboratories should be compared using the Student’s t -test for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun.