DESCRIPTION. PT is a remote control decoder paired with PT utilizing CMOS Technology. It has bit of tri-state address pins. PT Datasheet, PT Remote Control Decoder Datasheet, buy PT Remote Control Decoder. RF Decoder – PT – MHz. Sunrom Part#. Decodes variety of RF remote control transmitters at Mhz which uses encoder chip.

Author: Yomuro Samur
Country: Saudi Arabia
Language: English (Spanish)
Genre: Medical
Published (Last): 9 July 2011
Pages: 101
PDF File Size: 4.9 Mb
ePub File Size: 19.88 Mb
ISBN: 293-3-84328-349-9
Downloads: 2476
Price: Free* [*Free Regsitration Required]
Uploader: Telabar

Remote Control 315MHz by using RF remote control Encoder and Decoder

The only different is the RF frequency. Feb 21, at 7: Jan 18, at 1: Add a simple wireless control to a device, no addressing, no programming — used a MHz remote with this receiver and you have wireless control up to meters away under ideal conditions!

Mar 11, at Nov 29, at Now depending upon the type of application, the RF module is chosen. Oct 19, at 7: We generally use the 8-bit address code and 4-bit data code. The Led and the relay will be switch off. If you solder the address fatasheet with the “L”, it means you set the pin to low.

Remote Control MHz by using RF remote control Encoder and Decoder – Tutorial by Cytron

WirelessRemote Control. On the right of the top row there marked an “L”, where means this row is connected to GND.


Sep 3, datashset 6: Soldered the components onto the donut board. I would try to modify a wireless bell, to make an garage opener, and of course a controller for light in house. PT has a maximum of 12 bits of tri-state address pins providing toor address codes; thereby, drastically reducing any code collision and unauthorized code scanning possibilities.

If you solder it with “H”, it means high. I have 8 ch remote using pt and pt272 receiver respectively. How abt security in this encoder? Would it work with MHZ? In this tutorial, only 2 fluorescent lamps were using. So it has valid address. Only while the transmitter PT and receiver PT have the same address, they can communicate.

Dec 9, at Feb 25, at The tutorial is end here. Please continue discuss in technical forum. Could you do me a favor to forward this email to your purchasing department or your company Dahasheet This IC has Latch or Momentary output type.

And if you leave it alone, it means vacant. Direct contact of antennas.

When the A button is released, datsheet matching pin goes low. Hi all, Please continue discuss in technical forum. Aug 26, at If the address bits was not match the data will only be received by PT if the button was being pressed and did not released at the transmitter boardthis IC will remain in datasheett by mode.


It has 12 bits of tri-state address pins providing a maximum ofor address codes; thereby, drastically reducing any code collision and unauthorized code scanning possibilities.

RF Decoder – PT2272 – 433 Mhz

There are three states: Highly appreciated your datashee, thank you. ASK Transmitter input voltage: Jun 14, at 6: RF Modules are used wireless transfer data and low cost application.

HTML is not translated! Package Included 1 x Transmitter with battery 1 x Receiver. Thank you very much. Apr 11, at 4: Add to Wish List.

Nov 12, at 6: As shown above, jumper pad area is composed of three rows. It should works for MHz. Press the push button on the RF-TX board and observed the result obtained.

Apr 15, at 7: It encodes data and address pins into a serial coded waveform suitable for or IR modulation. One of the features Hope can get your explanation. Now the output was becoming 0.